Mine Fires, Experiences in Extinguishing Large Underground Mine Fires

Abstract

Mine fires are common the underground exploitation of mineral raw materials. With the development of mining science and practice, the methods of extinguishing mine fires using new methods and materials were also developed. Today, in mining practice, direct fire extinguishing with water or fire extinguishers, isolation of oxidation zones with insulating walls, installation of torket concrete on the walls of the pit room or use of special foams are most often used. Methods based on ventilation methods or the use of inert gases can also be encountered. All these methods are used to extinguish local oxidation processes, fires are localized in a part of the pit, ventilation department or goafs. This paper presents methods of extinguishing a mine fire where the fire zone covered a larger area and it was not possible to localize it in one part of the underground mine, the pit is completely closed and isolated until the oxidation process subsides due to lack of oxygen. At the time of the complete closure and isolation of the pit, several gas detectors remained in operation in the pit, through which the change in the composition of the pit air could be monitored during the still active pit fire. At the same time, samples of the pit atmosphere behind the isolation walls were regularly taken, their analysis was performed and they were compared with the data obtained using active gas detectors. The key question was when to reopen the pit, conduct an inspection and try to reactivate the pit operations. Although it is an underground brown coal mine, some experiences and knowledge can be applied and used in underground mines of other mineral resources threatened by pit fires. Experiences can also be applied in case of fire, where it is possible to control the fire zone only through insulating walls. It was established that changes in the activity of the pit fire were manifested both on the insulation walls and on the active gas detectors.