Laser Drilling of Printed Circuit Boards

Abstract

Many small holes need to be drilled in printed circuit boards to achieve a high packing density of circuit components. Even with NC control, conventional mechanical techniques are relatively slow and holes smaller than 035 mm diameter are difficult to achieve in production. Laser drilling has been suggested as a potentially fast technique capable of drilling small holes, so trials have been conducted on thin, flexible kapton board, and on 08 mm and 16 mm thick epoxide woven glass fabric board with 12 and 36 micron thick copper cladding. Using a 600 W CO2 laser, the proposed technique was to pre‐etch holes in the copper which would then act as a mask to the beam, so drilling only where etched holes existed. This technique was feasible on the flexible board, but not on the thicker boards because of damage to the copper. Using a pulsed Nd‐YAG laser to drill through both copper and laminate gave good results, but more work is necessary to eliminate occasional delamination of the copper around the hole. Through‐hole plating of the drilled holes appeared to present no special problems.